epoxy_coating

Avoiding Irregular Results with an Epoxy Coating

Although the threat of an epoxy coating becoming irregular due to improper applications or improper mixing, it is a very popular choice when coating a concrete surface. Select Surface Solutions in Orlando , FL offers on-site training to contractors that can help them to address these issues more effectively, and avoid problems altogether, but here are some tips. Addressing these issues might prevent you from having entirely avoidable problems with epoxy coatings.

Problems with Bubbles

In some cases, epoxy coatings on Orlando floors might start to show small bubbles after the application. These oftentimes appear in small clusters.

These bubbles sometimes form because air is trapped in the epoxy mix. You can avoid this by altering your mixing methods to ensure a more consistent mix, but the solution may not be what you think.

This is usually caused because the mixing is too vigorous, not too gentle. It’s not uncommon for contractors, wanting to ensure that everything mixes together currently, use a very fast mixing speed of 600 RPM or higher. This can actually exacerbate the problem, causing bubbles to form that are very difficult to get out of the epoxy coating.

Orlando contractors that find themselves having serious problems with this issue can get training to help employees learn how to handle concrete building materials better, but starting by backing off the rpms when mixing the epoxy might take care of the issue right away. Try lowering the mixing RPMs to somewhere between 300 and 500 RPM. Remember to use a spiral mixing blade and to mix the epoxy thoroughly. This means getting the blade to every part of the pail and moving it from bottom to top and vice versa, ensuring that the mixture is as consistent as possible.

Preconditioning the mixture will also help. If it’s colder than usual outside, make sure you bring the epoxy coatings inside so that they’re ready to use when you need them. Because of the climate, cold isn’t too much of a concern for epoxy coatings in Orlando, but problems can arise if the mixture isn’t warmed up before it’s used.

 Fixes and Repairs

On those occasions when there are issues with epoxy coatings, Orlando contractors do have options to remedy them without too radical a procedure.

Start by using 100 grit sandpaper to remove the bubbles. You should be able to do this with a belt sander with little difficulty. After you’ve removed the problem areas, clean them up thoroughly. Be sure no debris is left behind. You can then reapply the epoxy coating, repairing the damage.

If you need help with epoxy coatings in Orlando, remember that we’re here to help. We offer the highest quality training and technical support for decorative concrete contractors. We know the ins and outs of all the products we sell and, if you need an assist in learning how to get better results out of them, be sure to get in touch. With the right techniques, your results will be better and your clients much happier!